Argent Silver specifications

Use Argent Silver as a bright mirror silver foil for clean metallic decoration and test it on your own stock before production. Start with practical press settings, then refine to suit your die and press.

Hot stamping machine beside foil rolls, silver test sheets, and white sample boxes on a workshop table.

Foil use and finish

Argent Silver is a mirror silver hot stamping foil for decorative metal-effect finishing on coated paper, PET labels and folding cartons. It suits work where a bright silver look is needed on clean, well prepared stocks.

Use it for brand panels, labels, cartons and cover work where a crisp reflective silver is required. For related stock and press information, see Argent Silver substrates and Argent Silver press notes.

PropertyStarting point
Temperature window125 to 140°C
Release profileClean release
FinishMirror sheen
Suitable substratesCoated paper, PET labels, folding cartons

Press setup

Set up the press with proper make-ready and use the table above only as a starting point. Argent Silver should be tested on the same press, die and stock that will run the job, because foil response changes with surface, pressure and dwell.

  • Check the temperature window first, then adjust in small steps.
  • Set dwell so the foil transfers cleanly without overworking the stock.
  • Apply enough pressure for a full image, but avoid crushing the substrate.
  • Watch the release profile for a clean lift from the carrier.

The same foil family can behave differently on platen, cylinder and roll-to-roll equipment, so record what works on each press. For practical running notes, use the press notes.

Dies and make ready

Good make-ready matters as much as foil choice. Check the condition of the die, the evenness of the impression and the transfer area before production starts. Magnesium, copper and brass dies can all behave differently, so keep the test setup consistent when comparing results.

On fine detail or large solids, inspect edge sharpness, image fill and any signs of overheat or undertransfer. If the foil is not releasing cleanly, work back through temperature, dwell and pressure one at a time rather than changing everything at once.

Keep a short run record for each job: stock, press, die, settings and the result on your own substrate. That makes repeat work easier to set up later.

Supply and slitting

Argent Silver is supplied as foil rolls slit to the width you need for your job. The aim is to match the roll to your press and production setup so you can run with less waste and less trimming at the machine.

Ask for the roll format that suits your press line, then confirm the required width on order. If you need a supplied sample or swatch book before a production run, request it alongside your enquiry through the contact form.

For ordering steps, go to Order Argent Silver.

Test on your stock

The safest way to specify hot stamping foil is to test it on your own stock. Run a small sample on the exact paper, board or label face you plan to use, then check the image after cooling and after any varnish or finishing steps you intend to apply.

  • Confirm the silver finish on your actual substrate.
  • Check adhesion at the edges and in solids.
  • Review the result after handling and finishing.
  • Adjust one setting at a time until the transfer is consistent.

If you need press-side advice on temperature windows, dwell, pressure, release profiles or make-ready, ask Stampingfoil through the contact form. If you are planning a broader foil selection, start at Products.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form