Argent Silver substrates

Use this guide to match Argent Silver to the right stock and press setup. It shows where to start testing on coated, laminated and specialty substrates.

Foil stamping machine with silver embossed cards, shiny foil rolls, and a patterned metal die in an industrial workshop.

What argent silver is for

Argent Silver is a silver hot stamping foil for clean, reflective metallic decoration on print and packaging work. It is commonly used where a mirror-like silver finish is wanted on coated paper, PET labels and folding cartons.

The foil family is also checked on other substrates where appearance and adhesion can vary, including coated and uncoated board, soft-touch laminate, gloss laminate and UV varnish. For specialty work, see the related Specifications and Argent Silver press notes.

Substrates to test first

Start with the stock type, coating and surface energy of the printed piece. Smooth, well prepared surfaces usually give the cleanest transfer, while rough or heavily textured stocks may need more careful make-ready.

  • Coated paper and folding cartons for general print and packaging use
  • PET labels where release and fine detail need checking
  • Soft-touch and gloss laminate where surface treatment can affect transfer
  • UV varnish where the varnish layer changes the foil bond
  • Uncoated board where fibres may reduce sharpness
  • Leather, plastics and textiles only where the application calls for it and testing is possible

If you are unsure, test the exact substrate build, not just a similar board or film. A short trial is better than discovering an issue on a long run.

Set up your press

For make-ready, begin with the known starting point of 125 to 140°C and adjust within the practical window on your own press. The right setting depends on the substrate, die, impression and line speed.

CheckWhat to look for
Temperature windowStart within the stated range and confirm transfer on the actual stock.
DwellEnough contact time for the foil to release fully without softening the surface.
PressureEven impression across the image area, especially on fine type and solids.
Release profileClean release from the carrier with no picking, haze or patchiness.

These checks apply whether you are running platen, cylinder or roll to roll equipment.

Dies and detail

Die condition matters as much as press settings. Magnesium, copper and brass dies can all be used, but the image, run length and substrate should guide the choice. Crisp edges, even face depth and proper mounting help the foil release more consistently.

Fine lines, solid panels, small reverses and trap areas should be checked during make-ready. If the foil appears dull, broken or over compressed, review the die condition first, then recheck pressure and temperature. A short press-side test can show whether the image needs a different set-up before the main run starts.

Rolls and ordering

Argent Silver is supplied slit to roll width for the application and press format being used. The roll width should match your equipment and the image layout so that waste and trimming are kept under control.

Swatch books, samples and press-side advice are available to help you compare finish and release before ordering. If you need a quote or want to confirm the right roll width for your job, use the contact form. For the next step in the range, you can also visit Argent Silver or place an order through Order Argent Silver.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form