Aurum Gold specifications
Practical starting points for Aurum Gold on paper, board and soft-touch laminate. Use these notes to set up press tests, check release and confirm the slit width you need.

Start here
Aurum Gold is a metallic hot stamping foil for clean gold decoration on print and packaging work. It suits jobs where a bright gold finish is needed on paper and board, soft-touch laminate and rigid boxes.
Use the figures below as starting points only and test on your own stock before production. Press response changes with substrate, artwork coverage, die type and machine setup, so make-ready still matters.
| Specification | Starting point |
|---|---|
| Temperature window | 120 to 135°C typical |
| Release profile | Medium release |
| Finish | High brightness |
Substrates and presses
This grade is suited to paper and board, soft-touch laminate and rigid boxes. On coated board and laminate, check that the foil transfers cleanly without picking, patchiness or over-embossing at the edges of the image.
It can be tested on platen, cylinder and roll-to-roll presses. On each press type, confirm that the heated die reaches the stock evenly and that the impression stays consistent across the full image area.
- Check the stock surface before setup
- Confirm the die area is clean and properly seated
- Make sure the first pull gives a readable transfer before increasing production speed
Make-ready notes
Start with the temperature window above, then adjust dwell and pressure in small steps until the release is clean on your own stock. If the foil is not releasing fully, increase dwell or pressure gradually rather than making large changes at once.
If the image looks dull, broken or heavily struck, reduce the pressure or recheck temperature, die condition and stock coating. The right balance depends on the press, the artwork and the surface being stamped.
- Temperature sets the starting point for transfer
- Dwell controls how long the heat stays on the stock
- Pressure affects edge definition and full-area coverage
- Release profile should suit the substrate and image coverage
How it is supplied
Aurum Gold is slit to the roll width you need, so the foil can be matched to your press and job setup. Use the contact form if you need help choosing the slit width for a specific press or use.
For related setup information, see substrate guidance and press notes. If you are ready to place a job requirement, go to order Aurum Gold.
Swatch books and samples are available for practical comparison before you commit to production, especially when you are matching coated board, soft-touch laminate or rigid packaging finishes.
Test on your stock
The safest way to set up is to run your own stock through a short test on the actual press, with the actual die, artwork and surface finish you will use for the job. That is the best way to confirm the temperature window, dwell, pressure and release profile together.
Look for even transfer, crisp edges and consistent brightness across the image. If you are working with coated board, soft-touch laminate or rigid boxes, test more than one area of the sheet or board to confirm the result stays consistent.
- Test on final stock, not a substitute sheet
- Check adhesion and appearance after cooling
- Record the settings that work for repeat jobs
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
