Aurum Gold substrates

Aurum Gold is set up for clean transfer on the right stock, with practical guidance on where to test first and how to set up the press.

A print workshop table displays gold foil rolls, sample cards, and a hot stamping machine in a dim room.

What it suits

Aurum Gold is a metallic hot stamping foil for decorative gold transfer on a range of print and converting stocks. The foil family is usually a good starting point on paper and board, soft-touch laminate, and rigid boxes, where a bright gold finish is wanted.

On coated board and smooth laminate, start with a clean, even surface and check whether the coating or varnish sits well under heat. On uncoated board, the fibre structure can change the release behaviour, so a short press test is worth doing before any long run.

  • Coated and uncoated board
  • Soft-touch and gloss laminate
  • Rigid cartons and presentation packs
  • UV varnished stocks where the release is being checked

Where to test first

If the job includes a coated sheet, a laminate, or a surface finish, test a small area first and compare adhesion, coverage and edge definition. For UV varnish, check whether the varnish is fully cured and whether the foil releases cleanly without picking or patching.

On labels and self-adhesive constructions, test the full stack, not only the face stock. Adhesion can change with adhesive type, liner, topcoat and rewind tension. For plastics, leather or textiles, a substrate-specific test is essential because heat, texture and flexibility can all affect the result.

  • Labels and self-adhesive stock
  • Plastics where heat tolerance matters
  • Leather and textile applications
  • Any stock with a pronounced texture or coating

Press settings to check

The usual starting point for Aurum Gold is a temperature window of 120 to 135°C with a medium release. Treat that as a starting range only, then adjust to suit the press, the die, the substrate and the image area.

Make-ready should cover four checks: temperature window, dwell, pressure and release profile. The right balance changes on platen, cylinder and roll-to-roll presses, and also with the die material used. A magnesium, copper or brass die may need a different setup depending on image detail and the stock surface.

CheckWhat to look at
TemperatureStart in the typical range and confirm the cleanest transfer point
DwellLong enough for release, but not so long that the stock marks
PressureEven contact across the image, especially on fine detail
ReleaseClean lift from the carrier without smear or pinholes

How it is supplied

The foil is supplied slit to roll width, so it can be matched to the press and the job width being run. If you need a specific roll width for a platen, cylinder or roll-to-roll setup, ask for the closest practical slit width when ordering.

Swatch books and samples are available to help compare shade, brightness and transfer on your own stock. For repeat work, keep a record of the substrate, die, press type and the settings that gave the cleanest result. If you need help selecting a test strip or confirming whether the stock is suitable, use the contact form.

  • Slit to roll width for production use
  • Swatch books and samples for matching
  • Advice for make-ready and first pull tests

Related information

For the technical starting points, see Aurum Gold specifications. For press setup notes and testing guidance, see Aurum Gold press notes. To place an order, go to Order Aurum Gold.

If you are comparing foil families across other print applications, you can also browse products or the wider applications area for related hot stamping options.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form