Pigment Solid specifications

Use these starting points to set up Pigment Solid on your press and test it on your own stock. It suits common dark boards and cards where an opaque brand colour finish is needed.

Hot stamping press with foil rolls and sample cards showing gold and silver metallic finishes on a dark machine

what pigment solid is for

These are practical starting points for make-ready. Use them as a test base and adjust on press for your own stock, artwork coverage and equipment.

Foil familyTemperature windowLaydown
Pigment Solid120 to 140°COpaque

For the final colour selection and handling notes, keep the substrate type in mind. Dark boards and black paper usually need a careful test on the actual production stock, especially where the background has texture or coating. For more press-side detail, move to the Pigment Solid press notes.

set up the press

Check temperature, dwell, pressure and release profile together. A good result comes from balancing all four, not from changing only one setting.

  • Temperature: use the starting window and test in small steps
  • Dwell: begin with a short, even contact time and adjust for coverage
  • Pressure: apply enough to transfer the solid colour cleanly without crushing the stock
  • Release profile: confirm clean release where the foil should leave the carrier

On platen, cylinder and roll to roll presses, make-ready should include the die, the stock and the foil route. Brass, copper and magnesium dies can all behave differently, so test the job with the actual die, artwork coverage and finishing sequence.

how the rolls are supplied

The safest way to confirm suitability is to test on your own stock under your own production conditions. Run a small sample, check colour density, edge sharpness and release, then repeat only after the set-up is stable.

Pay attention to coated board, black paper and other surfaces that may respond differently to heat and pressure. If the stock includes soft-touch laminate, printed surfaces or a card coating, the release profile may need a separate check. For broader finishing options across plastics, textiles and leather, see Products or the Applications hub.

  • Test on the exact substrate you will use in production
  • Check whether the colour lays down evenly across solid areas
  • Confirm the result before committing to a full run
  • For more advice, use the contact form at Contact

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form