Security Micro specifications
Use Security Micro for microtext, covert markers and controlled supply on certificates, ID cards and duty seals. Start with practical press settings and test on your own stock.

What security micro is for
Security Micro is a security foil family for detail work where small, controlled elements matter. It is used for microtext, covert markers and jobs that call for controlled supply on certificates, ID cards and duty seals.
The starting points below are for trial and set-up work on common South African substrates. They help you narrow down the make-ready before you move into longer runs on platen, cylinder or roll-to-roll equipment. For substrate notes, see Security Micro Substrates.
Starting points
Use these as first test settings only. Adjust for your own stock, artwork, die and press condition.
| Item | Starting point |
|---|---|
| Foil family | Security Micro |
| Typical use | Microtext, covert markers, controlled supply |
| Temperature window | Test within a normal hot stamping starting range for your substrate and press |
| Dwell | Start with a short dwell and increase only as needed |
| Pressure | Use enough pressure to get a clean release without crushing detail |
| Release profile | Check for clean release, sharp edges and full image transfer |
If you are setting up a new job, test small areas first and inspect the fine detail under good light. Compare the result with your approved sample before you commit to the full run.
Substrates and presses
Security Micro is suited to common security and document work, including coated and uncoated paper stock, card, label stock and other surfaces used for certificates, ID cards and duty seals. It is also worth testing on the exact stock you plan to use, especially where coatings, laminations or surface treatments may affect release.
It can be tested on platen, cylinder and roll-to-roll presses. For soft-touch laminate or other specialty surfaces, make sure the substrate is fully cured or prepared as required before you start. If you need a broader substrate guide, go to Substrates.
Make-ready checks
Before production, check the press and die setup carefully. Small security elements depend on repeatable contact, clean release and consistent heat across the image area.
- Set a temperature window that gives transfer without over-softening the surface.
- Start with the shortest dwell that gives a clear image, then fine-tune.
- Use pressure that supports fine detail without flattening the microtext.
- Watch the release profile for crisp edges, even tone and no broken areas.
- Check die condition, flatness and makeready packing before longer runs.
For press-side notes and job adjustments, see Security Micro press notes.
Supply and ordering
Security foils are slit to the roll width you need, so you can match the roll to the press and the job. That makes handling easier on short runs, narrow labels and work that needs careful control of waste and register.
Ask for swatch books or samples if you are comparing finishes or setting up a new stock. If you are ready to place an order or need a custom slit width, go to Order Security Micro or use the contact form for a quote.
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
