Lead times

Lead times vary by foil type, slit width and whether you need stock or an indent line. Use the guidance below to plan production and send a complete enquiry.

Two people review metallic foil samples beside a hot stamping press, with gold and silver rolls and printed sheets visible.

What ships faster

Stocked metallic foils usually move the quickest when you need gold, silver, copper, bronze, mirror or satin finishes in standard widths. If your order is for a common application such as cartons, labels, book covers or general packaging, stock material is often the first place to start.

For faster handling, include your required foil type, roll width, quantity, substrate and press type in the contact form. If you already know the job name or repeat specification, mention that too so the order can be matched to the right reel and slit width.

  • Stock metallics are usually the quickest option
  • Confirm the exact width needed before release
  • State whether the job is for platen, cylinder or roll-to-roll work

What needs more time

Indent pigment lines and security foils can take longer because the specification must match the application more closely. The same applies where the job needs holographic or diffraction effects, or a foil made for a harder-to-run surface such as soft-touch laminate, plastics, textiles or leather.

When asking for lead-time guidance, tell support what finish you want, what the foil must adhere to, and whether the job uses magnesium, copper or brass dies. If you need samples first, request them through sample requests so the right range can be checked before production.

  • Indent pigment and security lines need closer matching
  • Specialty foils may require testing on the exact substrate
  • Samples help confirm appearance and transfer before ordering

How to plan your order

The cleanest way to avoid delays is to send a full job brief with your enquiry. A clear brief helps support confirm whether the foil is stocked, whether it must be slit to width, and whether the run needs any make-ready guidance for your press.

IncludeWhy it matters
Foil family and finishMetallic, pigment, holographic, security or specialty selection affects availability
SubstratePaper, coated board, soft-touch laminate, leather, plastics or textiles may need different testing
Press typePlaten, cylinder and roll-to-roll setups run differently
Die typeMagnesium, copper and brass dies can change transfer and release
Roll widthCorrect slit width avoids waste and rework

Test before the run

For difficult substrates, ask for press-side advice before production starts. A sensible starting point is to test a small section and check temperature window, dwell, pressure and release profile before committing to the full job. The exact setting depends on the foil, the die, the artwork and the surface being stamped.

If you are working on coated board or soft-touch laminate, mention that clearly. The same foil can behave differently from one surface to another, so a short test on the intended material is usually the safest way to confirm the setup. If you need practical help with make-ready, see technical help.

  • Start with a small test area
  • Check transfer, release and edge sharpness
  • Adjust one setting at a time so results are easier to read

What to send in the form

Use the contact form and include enough detail for support to confirm availability and timing. If you are unsure about the exact product, describe the finish you want and the end use instead of guessing a foil name.

  • Your foil type and colour family
  • Substrate and final application
  • Press type and die material
  • Roll width needed and any slit requirements
  • Whether you need stock, a sample, or a repeat order
  • Any make-ready notes, release issues or adhesion concerns

If you also need order setup guidance, see ordering rolls, or go back to support for the full help menu.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form