Bronze Cord specifications

Use these starting points to trial Bronze Cord on your own stock and press setup. Check temperature, dwell, pressure and release before running production.

Hot stamping press with bronze foil details on black samples and foil rolls in bronze and holographic colors

What Bronze Cord is for

Bronze Cord is a bronze finish foil for hot stamping where you want a warm, antique depth rather than a bright metallic shine. It suits branding, décor and pack decoration on substrates that take a clean impression.

This foil family is suited to leather, kraft board and wine cartons. If you are testing on other stock, start with a small run and check how the surface, coating and press settings affect transfer and adhesion.

For more on the foil family, see the Bronze Cord product page, or compare substrate notes on the substrates.

Starting points to test

Use these as trial settings only. Final performance depends on your stock, tooling and press condition.

Foil familyTemperatureReleaseLook
Bronze Cord130 to 145°CSoft releaseAntique depth

Work within the temperature window first, then adjust dwell and pressure in small steps. The aim is a clean transfer with even coverage, without overcooking the image or under-transferring the foil.

On coated board and carton work, watch for surface variation across the sheet. On leather, check how the grain takes the foil and whether the image remains readable after handling.

Press setup checks

Before you commit to production, confirm the press is clean, even and correctly set up for the job. Bronze Cord can be run on platen, cylinder and roll-to-roll presses, provided the tooling and settings match the substrate.

  • Dwell should be long enough for the foil to release into the substrate, but not so long that the image spreads.
  • Pressure should be even across the artwork and the press area.
  • Temperature should be tested within the stated window, especially when moving between coated board and porous stock.
  • Release profile should be checked for clean transfer and consistent edges.

If you need practical press-side guidance, see the press notes.

How to test on your stock

Run a small trial on the actual material you plan to use. That is the only reliable way to confirm finish, adhesion and detail on your own press and tooling.

  • Test the foil on the final substrate, not a substitute.
  • Check both solid areas and fine detail in the artwork.
  • Compare the result after handling, folding or abrasion relevant to the job.
  • Adjust one variable at a time, starting with heat, then dwell, then pressure.

If the result is too light, too dark or patchy, review the surface and the make-ready before changing too many settings at once. For related order steps, use the ordering guide.

How rolls are supplied

Bronze Cord rolls are slit to the width you need for your job. That helps reduce waste and makes it easier to match your press setup and artwork layout.

Supply options are handled to suit trade use, with swatch books and samples available where needed. If you are matching a new substrate or building a job spec, ask for advice through the contact form so you can confirm the right starting point before production.

For broader finishing references, browse the products range or the applications sections.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form