LeatherMark specifications

Use this guide to set up LeatherMark on leather goods and similar substrates. It covers starting points for temperature, dwell, pressure, release and roll supply.

Hot stamping press applying gold foil to a black leather-like card beside foil rolls in gold, silver and rainbow colours.

What LeatherMark is for

LeatherMark is a hot stamping foil family for leather goods and similar finishing work where a clean mark and controlled release matter. It is suited to wallets, belts and footwear, and it can also be tested on other leather articles where the surface and process call for a softer release profile.

It is intended for use on standard hot stamping equipment, including platen, cylinder and roll-to-roll presses. If you are moving from another foil family or changing substrate finish, start with small trial areas and adjust one variable at a time.

For a broader view of the range, see LeatherMark and the related substrates guide.

Starting points to test

Use the following as a practical starting sheet only. Final settings depend on stock, artwork, die type and press condition, so always test on your own material before production.

SettingStarting point
Temperature windowLower heat windows
DwellShort, then adjust in small steps
PressureLight to moderate, then increase only if needed
Release profileSoft release
Edge controlEdge clean

These starting points are meant to help you get into register, control laydown and keep edges tidy without overcooking the substrate.

Press setup checks

Before a full run, check the make-ready carefully. Confirm the die is mounted true, the artwork is clean, and the substrate is flat and secure. On leather, press condition matters as much as foil selection, so watch temperature stability, dwell consistency and pressure across the form.

  • Confirm the temperature window on your press and test the low end first.
  • Set dwell long enough for transfer, but avoid forcing the foil.
  • Use only the pressure needed for a complete impression.
  • Check release behaviour on the first pulls and inspect edge definition.

If you need help setting up dies or making first samples, use the LeatherMark press notes.

How rolls are supplied

LeatherMark rolls are slit to the width you need for your job, so the foil can be matched to your press and layout rather than forcing a standard width. That helps reduce waste on narrow work and keeps handling simple on short runs and repeat work.

Supply is arranged for trade use, with support for sample requests and swatch books where needed. If you are planning a new job, ask for a quote through the contact form and include your substrate, press type and die size.

To order, go to Order LeatherMark or visit contact.

How to test on your stock

Test on the exact stock you plan to run, including any coating, grain, finish or laminate on the surface. Leather can vary from panel to panel, so sample pulls should check coverage, adhesion, edge quality and how the foil releases from the die.

  • Start with a short trial at the lower heat end.
  • Change one setting at a time, then compare the result.
  • Record temperature, dwell, pressure and release behaviour for repeat jobs.
  • Check the finished piece under handling and flexing before release to production.

For substrate-specific guidance, move between substrates and press notes, or view related finishing areas at applications and products.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form