LeatherMark

Soft-release foils for leather goods that need clean edges, steady release and reliable handling on the press. Use LeatherMark for wallets, belts, footwear and similar finished leather work.

A workshop with rolls of gold and silver foil, a black stamping press, and embossed leather samples on a table.

What it is

LeatherMark is a soft-release foil family for genuine leather and PU leather where the finish needs to sit cleanly without harsh pull on the surface. It is suited to leather goods that call for neat detail, consistent edge definition and a controlled release from the die.

It is commonly used on items such as wallets, belts and footwear, where the surface can vary from piece to piece and the press setup needs to be practical rather than difficult. For broader foil family options, see product families.

  • Soft release for leather work
  • Cleaner edge transfer on suitable leather surfaces
  • Made for finished leather and PU leather
  • Useful where the press operator needs repeatable handling

Where it suits

This foil family is intended for leather applications where appearance and handling matter, especially on goods that are handled often and need a neat decorative mark. It suits genuine leather and PU leather when the surface is prepared for hot foil stamping.

Typical use cases include wallets, belts and footwear. If you are comparing foil families for different materials, you can also look at PlasticBond for plastics and TextileSheen for textiles.

UseNotes
WalletsGood for small marks, logos and brand details
BeltsUseful where the leather is finished and the press area is controlled
FootwearAppropriate for decorative and branding elements on suitable leather parts

Press setup

For leather, the make-ready should start with the press, die and surface condition. Check the temperature window on a sample run first, then adjust dwell, pressure and release until the mark is clean and the foil releases evenly.

Start with practical test settings rather than fixed assumptions. Leather surfaces can vary, so the operator should confirm the result on the exact material, finish and grain being used. Magnesium, copper and brass dies may all be used depending on the job, with the die choice matched to detail and heat transfer needs.

  • Test the temperature window before production
  • Balance dwell against surface sensitivity
  • Use enough pressure for clean transfer, not excessive crush
  • Check release profile for clean lift and edge definition
  • Confirm make-ready on the same substrate batch where possible

Supply and ordering

LeatherMark is supplied slit to roll width for production use, so it can be matched to the press width and the job format. If you need swatch books or samples before ordering, ask for those first so the finish can be checked against your leather and your press setup.

Roll supply is useful for repeat work, while samples help with trial stamping and approval. For ordering help, go to Order LeatherMark or use the contact form to ask for a quote.

  • Supplied in roll form slit to width
  • Samples available for testing
  • Swatch books available on request
  • Suitable for planned production and trial runs

Related guidance

If you are setting up a leather job, the most useful next steps are the specification sheet, the substrate guide and the press notes. These pages cover the details that affect transfer, surface finish and run stability.

If you are comparing it with other foil families, the broader product range includes metallic, pigment, holographic, diffraction, security and specialty foils across a number of substrates. See Product families for the full range.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form