LeatherMark substrates
Use LeatherMark when you need a clean foil transfer on leather and related finishes. Start with short tests on the right substrate before any long run.

What LeatherMark is for
LeatherMark is a specialty hot stamping foil family for leather goods and other surfaces where a neat edge and controlled release matter. It is used on wallets, belts and footwear, and can also be checked on compatible plastics and textiles where the finish and substrate allow transfer.
The foil family is intended for work where a lower heat window and soft release are helpful. That makes make-ready important, especially if you are moving between natural leather, coated materials and mixed production work. For other foil types and finishes, see LeatherMark Specifications.
Substrates to test first
Start with the substrate itself, then move to finish layers and any surface treatment. LeatherMark should be trialled first on:
- Natural leather and leather goods
- Soft-touch laminate
- Gloss laminate
- Coated board
- Uncoated board
- UV varnish
- Labels and similar converted work
- Plastics and textiles where the base material is suitable
Because coating, texture and absorbency change transfer behaviour, do not assume one setting will suit all stocks. If you are comparing press results against other make-ready notes, check the LeatherMark press notes.
Press setup to check
Set up with a short test strip before any full production run. The usual starting checks are temperature window, dwell, pressure and release profile. On leather and soft-touch materials, begin with the lower end of your normal stamping range and increase only if the foil does not cleanly release.
Keep an eye on edge definition, fill across fine detail and any signs of overheat, bite-through or pickup. Platen, cylinder and roll-to-roll presses can all be used, but each press type needs its own make-ready and trial steps. Magnesium, copper and brass dies should also be checked for even heat transfer and clean image edges.
Make-ready notes
For clean transfer, prepare the job before opening the roll fully. Check the die face, substrate flatness, pressure balance and the consistency of the heated area. On textured leather or coated stocks, small changes in pressure can affect the release more than expected.
Useful points to confirm during make-ready include:
- Die temperature stabilisation before the first pull
- Even pressure across the image area
- Enough dwell for the foil to release cleanly
- A release profile that avoids picking on the back of the foil
- Trim and waste removal around the image
If you need help matching foil choice to finish type, the contact form is the right place to ask for advice.
Rolls and ordering
LeatherMark is supplied slit to roll width for production use. That makes it easier to match the roll to the press, the image width and the way the job is being run. Swatch books and samples are available for practical checking before ordering a full quantity.
When you place an order, have the substrate, press type and image detail ready, along with any issues seen on previous trials. If you need the next step in the range, move to Order LeatherMark, or go back to the parent page at LeatherMark for the full product set.
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
