Prism Holo press notes
Use these notes to get Prism Holo closer to the swatch on press. The foil suits security seals, youth packaging and event tickets when make-ready is set carefully.

What Prism Holo is for
Prism Holo is a diffraction foil family used where a bright moving pattern and tamper cue are part of the design. It is commonly specified for security seals, youth packaging and event tickets, and it can also be used on other short-run branded work where the holographic effect needs to stand out.
The finish is intended for hot stamping on suitable board, label stock and selected coated substrates, as well as other approved materials in the foil family. If you are matching a particular look, keep the specifications close at hand and check the substrate notes before press setup.
Set up the press
Start in the typical temperature band of 125 to 140°C and test from there, because the right setting depends on the press, the die, the substrate and the image area. Use the same approach for platen, cylinder and roll-to-roll work, but do not assume one setting will carry across all jobs.
Watch dwell time, pressure and release together. Too much heat or dwell can flatten the diffraction effect, while too little can leave weak transfer. On make-ready, check packing, nip, impression balance and web tracking so the foil releases cleanly rather than fighting the die.
| Check | What to look for |
|---|---|
| Temperature | Start in the 125 to 140°C range and adjust to suit the job |
| Dwell | Enough contact for transfer without dulling the pattern |
| Pressure | Even impression across the image and across the web or sheet |
| Release | Clean foil release with no drag, haze or broken pattern |
Choose the right die
Die choice matters on holographic work because the image can show faults quickly. Magnesium is often used for simpler or shorter runs, copper is suited to finer detail and brass is preferred where durability and fine control are needed. Match the die to the detail in the artwork and the amount of press work expected.
If the image has small elements, dense pattern or tight registration, ask for advice before running. A poor die choice can create fill-in, feathering or patchy transfer even when the foil itself is correct. Press-side advice is available on temperature windows, dwell, pressure and make-ready, and it is worth using before the first sheet or reel goes through.
Fix common faults
Fill-in usually points to too much heat, too much pressure, or a die that is too fine for the job. Try backing off the heat, checking packing and confirming that the artwork is not closing up under impression. Feathering often means the foil is not releasing cleanly, so review dwell and pressure, then check the surface energy and finish of the substrate.
Flaking and poor adhesion are often linked to unsuitable substrate prep, incorrect setting, or an overworked make-ready. On coated board and soft-touch laminate, test before full production and allow for the finish on the board. If the foil looks dull or broken, confirm that the web, tension and die face are clean and that the press is holding a steady impression.
Supply and next steps
Prism Holo is supplied as slit rolls to the required roll width for the press and job format. Keep the roll stored correctly before use, and handle it carefully so the release layer is not marked or creased before make-ready begins.
For substrate matching, see the substrates. To place an order, use ordering, or go to the contact form for a quote and press advice. You can also return to the parent Prism Holo section for the product overview.
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
