Prism Holo specifications
Use these starting points to trial Prism Holo on your own stock. Check the foil on press, then refine temperature, dwell, pressure and release to suit the substrate.

What Prism Holo does
Prism Holo is a diffraction foil for decorative sparkle and visible tamper cues on packaging and printed products. It is commonly trialled on security seals, youth packaging and event tickets where a distinct holographic look is wanted.
It is suitable for common hot stamping work on labels, cartons, book covers and similar printed surfaces, and can also be tested where a sharper security finish is needed. For adjacent technical notes, see Prism Holo press notes.
As with any hot stamping foil, the final result depends on the stock, the die, the press and the make-ready. Use these specifications as a starting point, then test on the actual substrate you will run.
Starting points
Begin with the following settings and adjust in small steps on press until release and edge definition are right for your stock.
| Specification | Prism Holo |
|---|---|
| Temperature window | 125 to 140°C |
| Dwell | Start with a short dwell and increase only if the foil is not fully transferring |
| Pressure | Start with enough pressure for full contact without crushing the board or film |
| Release profile | Test for clean release with a bright diffraction sparkle and no lift-back on the edges |
If you need substrate-specific guidance before you run, compare the substrate notes in the Prism Holo Substrates.
Substrates to test
Prism Holo can be trialled on a range of common SA substrates, including coated board, labels, cartons and certain plastic or laminate surfaces where the surface energy and finish are suitable. It may also be used for specialty work on soft-touch laminate when the make-ready is correct.
- Check that the surface is clean, dry and free from dust or release contaminants.
- Confirm whether the stock has a coated, uncoated or film face before setting the press.
- Test on the actual production board or roll material, not a substitute sheet.
- Watch for patchy transfer, over-embossing, edge feathering or scuffing after handling.
For other foil families used on leather, plastics and textiles, see products.
Press setup
Use the foil on platen, cylinder or roll-to-roll presses according to the tooling and substrate. Keep the die, makeready and pressure balanced so the holographic pattern transfers evenly across the image area.
- Warm up into the stated temperature window before taking production samples.
- Check dwell first if the transfer is incomplete, then adjust pressure if needed.
- Use the die type and image detail that suit the stock and the press format.
- Review release at the leading and trailing edges as well as the fine pattern detail.
For a practical supply check or to discuss your press setup, use the contact form.
Supply and testing
Rolls are slit to the width you need, so the foil can be prepared for your press and your job format without unnecessary waste. Swatch books and samples are available to help with approval work before you commit stock to a run.
When testing, run short samples across the real substrate, then compare the transfer under handling and light. Check how the foil behaves on the exact make-ready you plan to use, including die hardness, impression depth and cleaning between runs.
If you are planning a new job, ask for press-side advice on temperature windows, dwell, pressure, release profiles, dies and make-ready. If you want to move from sample to order, use Order Prism Holo.
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
