TextileSheen specifications

Use TextileSheen as a practical starting point for textile foiling on suitable labels, caps and soft goods. Test your own stock and confirm make-ready before production.

Hot stamping press beside stacked foil rolls and sample cards in gold, silver and holographic finishes

What TextileSheen is for

TextileSheen is a foil family for decorative and brand marking work on textile-related items where a clean stamped finish is needed. It is suited to apparel labels, caps and soft goods, and should be checked on the exact stock before a run.

The foil is meant to be trialled on your own materials, because textile blends, coatings and finishes can change how the foil releases. For production planning, start with the TextileSheen press notes and review the stock options in the TextileSheen Substrates.

  • Use for brand marks and decorative foil detail on textile applications
  • Check the surface finish, coating and heat tolerance of the item first
  • Confirm the result on the intended fabric, label or soft goods item

Starting settings to test

Use these as starting points only. Adjust on press to suit your stock, artwork size and line speed. The right result depends on substrate, die, press type and the way heat is transferred.

ItemStarting point
Foil familyTextileSheen
Temperature windowTypical starting range to test on your stock, not a promise
DwellTypical starting range to test on your stock, not a promise
PressureTypical starting range to test on your stock, not a promise
Release profileCheck for clean release after cooling and inspect edge detail

If the foil is not releasing cleanly, or if the image looks light, patchy or over-pressed, change one setting at a time. Keep a record of what worked on the same stock for repeat jobs.

Press and make-ready checks

Before the first test, make sure the die, substrate and press setup are matched. Textile foiling can behave differently on platen, cylinder and roll-to-roll presses, so make-ready needs to be checked on the actual machine you will use.

  • Confirm the temperature window on the press rather than relying on a generic setting
  • Set dwell so the foil transfers without marking or distortion
  • Apply pressure evenly across the stamp area
  • Check the release profile after the sheet or item has cooled enough to inspect
  • Verify the die condition and the flatness of the item before running volume

For practical guidance on die choice and make-ready, see TextileSheen press notes.

Substrates and trial work

TextileSheen is intended for textile-related work and should be tested on the exact substrate you plan to use. Suitability can vary with fibre content, coatings, construction and surface texture.

Start with the intended item, not a substitute. A result that looks good on one label or soft goods sample may behave differently on another. If you are building a new job, compare several test stamps before approving the final setup.

  • Check adhesion and appearance on the actual fabric or label
  • Test whether the finish holds its detail after handling
  • Inspect the background colour and surface texture for visible interference

Use the substrate guidance in the TextileSheen Substrates to plan your trial run.

How it is supplied

Foil rolls are slit to the width you need, so the supply can be matched to your press and job setup. This helps reduce unnecessary waste and makes it easier to run the foil on the equipment you already use.

Swatch books, samples and press-side advice are available to help with testing and make-ready. If you need help deciding how to trial TextileSheen on your own stock, use the contact form and ask for a quote or technical guidance through Contact.

  • Foil supplied slit to roll width needed for the job
  • Samples available for test work
  • Advice available on temperature windows, dwell, pressure and release

When you are ready to place or plan an order, go to Order TextileSheen.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form