TextileSheen substrates

TextileSheen is built for clean transfer on selected textiles and trims. Check the substrate first, then match the press setup before a long run.

Hot stamping machine beside foil rolls and sample cards showing gold, silver and holographic finishes.

What it is for

TextileSheen is a flexible hot stamping foil family for textiles and related soft goods where a clean branded mark is needed. It suits apparel labels, caps and similar items where the surface can take a foil transfer and where the application is set up with care.

Use it with a practical make-ready approach. The foil family is intended for controlled transfer, with press settings checked against the substrate, the die and the surface finish before production starts. If you are planning a new application, start with the sibling pages for specifications and press notes.

Substrates to test first

As a rule, test first on the exact material you plan to run. TextileSheen may suit textile labels, caps and other soft goods, but surface finish and construction can change the result. On coated or uncoated board, soft-touch and gloss laminate, UV varnish, labels, plastics, leather and textiles, the right result depends on the coating, the texture and how the press releases the foil.

  • Coated board and uncoated board can behave differently, so test both if your job changes stock.
  • Soft-touch and gloss laminate often need careful checking for adhesion and release.
  • UV varnish can affect transfer, so confirm the mark after make-ready.
  • Plastics, leather and textiles need substrate-specific trials before a long run.

If you need matching advice for another foil family, see the broader products area.

Press setup checks

Before you commit to production, check the temperature window, dwell, pressure and release profile on your actual press and substrate. Use a narrow starting range and confirm how the foil releases from the carrier, especially where the design has fine detail or solid areas.

SettingWhat to check
TemperatureStart with a typical trial range for the substrate and adjust to clean transfer, not to force the foil.
DwellKeep the contact time consistent while you find the point where the foil transfers cleanly.
PressureSet enough pressure for full contact without crushing the substrate or distorting the image.
ReleaseWatch how the carrier lets go at the edge, in solids and in fine text.

For press-side setup notes, use the sibling press notes.

How to run TextileSheen

Good make-ready matters. Check the die condition, image depth and registration before the first pull. Magnesium, copper and brass dies each bring different heat and wear behaviour, so confirm the die matches the job, the press and the level of detail you need.

  • Make sure the substrate is flat enough for clean contact.
  • Confirm the die face is even and clean.
  • Check register on the actual job layout, not only on a proof sheet.
  • Run a short test strip before any long run.

On platen, cylinder and roll-to-roll presses, the same basic checks apply, but the exact setting will vary. Where the substrate is difficult or the artwork is fine, ask for press-side advice before committing to full production.

Supply and ordering

TextileSheen is supplied slit to roll width for production use, with swatch books and samples available for practical matching and testing. If you need a recommendation for a specific textile or soft good, ask for guidance before ordering the full job quantity.

For roll width, sample requests and order preparation, go to Order TextileSheen. If you need a supplier contact route, use the contact form. For related finishes and applications, the broader applications and finishes sections may also help.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form