WoodGrain press notes
Use these make-ready notes to keep WoodGrain close to the swatch on press. Check heat, dwell, pressure and release before you run.

What WoodGrain is for
WoodGrain is a hot stamping foil family for jobs that need a timber look without printing a wood image. It suits plaques, awards and display props where a defined grain effect must sit cleanly on the substrate.
It is commonly run on rigid or semi-rigid work where the surface is even and the detail must hold through short to medium production runs. For related substrate guidance, see WoodGrain Substrates.
- Use for decorative lettering, borders and panel details
- Keep artwork clear and simple where the grain must read well
- Check the substrate surface before setting the die
Make-ready checks
Start with the foil swatch and match the press setup to the look you want. The first checks are temperature window, dwell time, pressure and release, because WoodGrain will change appearance if any one of these is out.
Use a modest starting temperature and test in small steps rather than pushing heat too far at once. On coated board or soft-touch laminate, watch for surface sensitivity and adjust the window before running a full stack.
- Confirm the foil is feeding flat and evenly
- Check packing so the image transfers across the full area
- Trim make-ready waste before the long run begins
Choose the right die
Die choice matters on WoodGrain because the texture and edge hold depend on how the image is cut and how heat moves through the tool. Magnesium, copper and brass all have a place, but the job size and detail level should guide the choice.
For fast make-ready and short runs, spot dies are often practical. If the job needs finer definition or repeated contact, a harder die may give steadier transfer. The press type also matters, whether platen, cylinder or roll-to-roll.
| Die | Typical use | Press note |
|---|---|---|
| Magnesium | Short runs and simpler marks | Quick to set, watch heat control closely |
| Copper | More detailed work | Useful where definition must stay even |
| Brass | Longer running or repeated use | Helps where stability is important |
Press faults and fixes
When WoodGrain does not hold, look first at the transfer conditions, not the artwork. Fill-in usually points to too much heat, too much pressure or dwell that is too long. Flaking and poor adhesion often point to heat that is too low, pressure that is uneven or release that is not clean enough.
Feathering at the edges can come from incorrect packing, a die that is not sitting square, or a substrate that moves during transfer. Adjust one setting at a time so you can see what the press is doing.
- Reduce heat or dwell if the grain closes up
- Increase heat carefully if transfer is patchy
- Recheck pressure and packing if edges are soft
Supplies and ordering
WoodGrain is supplied slit to roll width for the job at hand, with swatch books, samples and press-side advice available to help you set up. If you need help matching the foil to the substrate or press, ask for guidance before the run starts.
For the production route, see WoodGrain Specifications and Order WoodGrain. If you need a broader view of finishing options, visit Products or send the job details through the contact form.
- Foil supplied to roll width for practical press handling
- Useful for short runs and repeat set-ups
- Ask for a quote through the contact form
What our Hot Stamping Foil customers say
Verified Google reviews
Also worth a look



Ask about a foil for your job
Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.
Open the contact form
