WoodGrain

A specialty foil for wood, acrylic and rigid display pieces. Use it for short runs, plaques, awards and novelty items that need a clean stamped finish.

Hot stamping machine with a gold woodgrain die, foil rolls, and sample cards in a workshop.

What WoodGrain is

WoodGrain is a specialty hot stamping foil made for decorative transfer onto wood, acrylic and other rigid novelty items. It is suited to work where a defined surface detail and a controlled stamped image matter more than broad coverage.

It is commonly considered for plaques, awards and display props, especially when the design needs to hold on hard, uneven or coated surfaces. For related foil families, see metallic finishes, solid colours and leather foils.

Where it suits

This family is used on rigid items where the stamp area is small to medium and the artwork is defined. It is a practical choice for spot dies, short runs and pieces that are handled individually during finishing.

  • Plaques and awards
  • Display props and presentation pieces
  • Rigid wood items
  • Acrylic parts and novelty blanks
  • Decorative panels and branded inserts

For broader product families, see products and the related applications sections.

Substrates to check

Before production, check the surface structure, coating and heat tolerance of the blank. Wood can vary by grain, sealant and finish. Acrylic and other rigid plastics may need closer checking for surface sensitivity, especially where the item is polished or coated.

Soft-touch laminate and other special finishes can also change release behaviour. If the blank is part of a mixed-material build, test each surface separately before running the full job. The substrates notes set out the usual points to review.

MaterialWhat to watch
WoodGrain, sealer, flatness and heat response
AcrylicSurface sensitivity, gloss and mark-up risk
Rigid novelty itemsShape, hardness and consistent contact
Soft-touch or coated partsRelease behaviour and adhesion across the surface

Press setup

Start with the press type that matches the job. WoodGrain can be worked on platen, cylinder and roll-to-roll presses, provided the tooling, dwell and pressure are matched to the substrate and the stamp area. Spot dies are often the right starting point for smaller images and short runs.

On make-ready, check temperature window, dwell, pressure and release profile together, not one at a time. A typical starting test range is used to find the cleanest transfer, then adjusted for the actual blank, die and artwork. If the finish is patchy, too heavy or too light, review contact, pressure balance and dwell before changing anything else.

For detailed running notes, see the press notes.

Ordering and support

Foil is supplied slit to roll width to suit the press and the job format. Swatch books and samples are available for selection and proofing, and press-side advice is available on temperature windows, dwell, pressure, release profiles, dies and make-ready.

If you are setting up a new item or matching a repeat job, use the four support pages to move from selection to production:

To request a quote or ask about roll width, use the contact form.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form