WoodGrain specifications

Use these starting points to set up WoodGrain on test stock and dial in your press before a production run. The aim is clean definition, even release and practical make-ready.

Hot stamping press beside shelves of gold, silver and holographic foil rolls, with sample sheets on a table.

What WoodGrain is for

WoodGrain is a decorative hot stamping foil finish for plaques, awards and display props where a warm timber look is needed on a printed or converted item. It is used as a foil finishing option rather than a printed woodgrain image, so the press setup and substrate condition matter.

For the right result, treat it like any other specialty foil trial. Start with a clean, flat surface, then check how the grain pattern transfers at the chosen die area. If you are matching it to a board, laminate or coated stock, start by reviewing the related WoodGrain substrates notes and compare them with your own stock.

Starting points to test

Use these as practical starting points only. Adjust for your press, die and substrate, then confirm on your own stock before moving to production.

ItemStarting point
Foil familyWoodGrain
SuitsPlaques, awards, display props
PressesPlaten, cylinder and roll-to-roll presses
Known starting substratesRigid heat sinks
Die typeSpot dies
Run lengthShort runs

For temperature, dwell, pressure and release profile, use your normal first-pass setup for a specialty foil and test within the usual hot stamping window for your press. If the foil is not releasing cleanly, adjust one setting at a time and keep notes. For a fuller press checklist, see WoodGrain press notes.

How to set up the press

On make-ready, check four things first: temperature window, dwell, pressure and release. These work together. Too much heat or dwell can blur the pattern. Too little pressure can leave the grain incomplete. Release needs to be even, with no patchy pull or tailing at the edge of the image.

  • Confirm the stock is flat, clean and stable enough for stamping.
  • Use a spot die where the design area is controlled and the image is not overworked.
  • Test one press setting at a time so you can see what changed.
  • Check the first sheet or first impression, then inspect the edge detail and fill.
  • Record the final setup for repeat work on the same substrate.

If you need a second opinion while setting up, ask for press-side advice through the contact form.

How it is supplied

WoodGrain is supplied as roll stock and slit to the width you need for the job. The foil is prepared for trade use, so it can be matched to the press format and trimmed for practical handling at the machine. No stock dimensions are listed here because the right slit width depends on your application and press route.

If you are ordering for a repeat run, keep your working notes with the approved sample so the next setup starts from the same point. Swatch books and samples are available to help compare the finish against other foil families and substrate choices, including other product ranges.

Test on your own stock

The safest way to approve WoodGrain is to test it on the exact board, plaque blank or display material you plan to use. A result on one substrate does not automatically carry over to another, especially where coating, laminate or surface texture changes the way the foil releases.

  • Run a small trial area before full production.
  • Check adhesion, edge sharpness and grain clarity after cooling.
  • Compare the trial to your target look under the same light.
  • If needed, repeat the test with one variable changed only.

When the setup is close and you are ready to place the order, use Order WoodGrain or go back to the WoodGrain overview for the full range of notes.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form