Order Matte Velvet

Use these ordering notes to request Matte Velvet in the right width, length and quantity. Start with samples, confirm the substrate and press, then ask for a written quote through the contact form.

Hot stamping foil rolls, sample cards, and cardboard boxes arranged around a foil press in a workshop

what to include in your enquiry

For a clean quote, include the substrate, press type, roll width, roll length, quantity and the town or delivery point. If the job is for a specific run, add the product name, the finish you want to achieve and whether you are testing on coated board, uncoated stock, journals, luxury sleeves or another surface.

Mention any make-ready details that affect the result, especially the temperature window, dwell, pressure and release profile you plan to start with. If you already know the die material, include that too, whether it is magnesium, copper or brass. If you are unsure, ask for press-side advice before the order is confirmed.

For first orders, request swatches or samples before committing to full rolls. That is the simplest way to check appearance, coverage and handling on your stock.

roll widths and slitting

Matte Velvet can be supplied slit to roll width for the job at hand. Tell us the press width and the roll width you need, and note whether the roll is for platen, cylinder or roll-to-roll work. If the width needs to suit a narrow logo, panel or edge detail, ask for the slit size in the enquiry so it can be matched correctly.

Where practical, order only the width you will actually use. That helps keep setup tidy and reduces waste during make-ready. If you are comparing widths for more than one press or application, send each requirement separately so the foil can be quoted and supplied clearly.

For related technical details, see Matte Velvet specifications and Matte Velvet substrates.

samples first

Before placing a production order, ask for a sample or swatch book where needed. Matte Velvet is a low glare finish with a velvet hand, so it is worth checking how the appearance reads on your exact stock under your press conditions.

Test it on the substrate you plan to use, especially on uncoated stock, journals, luxury sleeves and other surfaces where touch and matte appearance matter. If the job includes coated board or soft-touch laminate, say so early because the release and temperature window may need closer attention.

Sample testing is also the best time to confirm whether the job needs a firmer or softer pressure setting, and whether the finish is holding detail cleanly at the planned dwell.

packing and collection

Rolls are supplied for trade use and can be collected or sent by courier, depending on the arrangement made on the order. If you are collecting, confirm the trade counter details and make sure the order reference is included. If it is being couriered, give the full delivery town and contact details on the enquiry form.

When the rolls are packed, keep them protected from unnecessary handling and site damage. On receipt, check the slit width, outer condition and label details before moving into production. If you need more than one roll width or a mix of sample and production material, ask for the packing to be listed clearly.

For ordering and collection, use the contact form.

press notes to confirm

For Matte Velvet, start by checking the press notes before you lock in a full run. A typical starting range is 115 to 130°C, but that is only a test window. Final settings depend on the stock, press, die and the finish you need to hold.

CheckWhat to confirm
TemperatureStart in the test window and adjust for the stock.
DwellSet enough contact time for clean release and fill.
PressureUse the lightest pressure that still gives full transfer.
ReleaseWatch for a clean lift with no haze, break-up or drag.

If you want the full technical setup, read Matte Velvet press notes or go back to the Matte Velvet overview before sending your enquiry.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form