Inkline Process

Inkline Process is made for consistent brand colour on press-critical work. Use it when matched pigment, clean solids and repeatable make-ready matter.

A hot stamping press with gold foil, sample cards, holographic foil rolls, and white packaging boxes in a workshop.

what it is for

Inkline Process is a pigment foil range for work where colour needs to stay consistent from run to run. It suits brand kits, seasonal SKUs and retail labels where the stamped colour must sit closely to the approved artwork.

Use it when a solid pigment finish is preferred over a metallic effect. The range is supplied as rolls for hot stamping and can be specified for trade work across product families and related finishing jobs.

  • Matched batches for consistent repeat work
  • Tight colour control for brand-critical jobs
  • Trade proofing support before production

where it works

This family is commonly chosen for coated board, cartons, labels, book covers and other finished print items that need a clean pigment stamp. It is also used where a solid colour mark is preferred on packaging components and promotional print.

For other looks and applications, compare it with sibling ranges such as Pigment Solid, Aurum Gold or Chrome Mirror if you need a metallic effect instead of pigment.

Typical useWhat to check
Coated board and cartonsSurface smoothness, image area and release needs
Retail labelsFine detail, press speed and cure or varnish steps
Book coversCoverage, impression stability and trimming

substrates to test

Always test the foil on the actual substrate, coating and finishing sequence to be used in production. Pigment foils can behave differently on paper, board and specialty surfaces, especially where varnish, soft-touch laminate or heavy ink coverage is involved.

For non-paper applications, review the dedicated substrate guidance pages before ordering. The most relevant links for this family are Inkline Process substrates, PlasticBond, TextileSheen and LeatherMark.

  • Test coated and uncoated board separately
  • Check adhesion over printed and varnished areas
  • Confirm performance on soft-touch laminate before full run

press setup notes

Start with press-side trials and adjust to the specific die, substrate and machine. Typical starting points are a temperature window of around 90 to 120 degrees Celsius, moderate dwell, enough pressure for full transfer, and a release profile that lifts cleanly without picking.

These are only starting ranges for testing. Use make-ready to balance impression, dwell and heat so the foil releases evenly on platen, cylinder or roll-to-roll equipment. Magnesium, copper and brass dies may all need different settings depending on artwork and surface.

For a fuller checklist, use the detailed guidance in Inkline Process press notes.

Ordering and roll supply

Foil is supplied slit to roll width to suit the job and the machine. That helps keep waste down and makes it easier to load the press with the width needed for the format in production.

Before ordering, confirm artwork, substrate, press type and the finished roll width needed. Swatch books and samples are available for proofing, and you can request help through the ordering notes or the contact form.

What our Hot Stamping Foil customers say

Verified Google reviews

Ask about a foil for your job

Send a note through our contact form with the substrate, the press you run (platen, cylinder or roll-to-roll), the finish you are after and the run length, and we will come back with a foil grade, a sample and a quote.

Open the contact form